Page 1 of 1

ICOM 2200H Program Receive Freqs?

Posted: Tue Apr 20, 2010 1:54 pm
by W9LCL
Trying to program some low freqs. (118.400) into my 2200. The receive range is supposed to be 118.00 to 174 or 176 MHz. When programming, the first digit is always 1 (as it should be). But when I turn the dial to set the second digit, that digit toggles between 2-3-4-5-6; in other words, no way to program anything below 120.000 or above 169.975. Undoubtedly operator error--can anyone tell me what I am doing wrong? As usual, re-re-re-reading the manual hasn't helped. 73 to all. Tom W9LCL

Icom programming

Posted: Sun Apr 25, 2010 3:26 am
Programming an Icom is a real treat,start a a given page then bounce around to about six more,Oh Yes pray it doesn't time out before your finished.Buy the programming software,Write your own Instruction sheets, or trade it for a Yaesu
Good Luck & Happy Swearing