ICOM 2200H Program Receive Freqs?

Just what it says -- this is the place for any discussions not related to Buying, Selling and Trading ham gear. The discussion must be related to Ham Radio.
Post Reply
W9LCL
Posts: 26
Joined: Tue Jul 07, 2009 1:46 pm

ICOM 2200H Program Receive Freqs?

Post by W9LCL » Tue Apr 20, 2010 1:54 pm

Trying to program some low freqs. (118.400) into my 2200. The receive range is supposed to be 118.00 to 174 or 176 MHz. When programming, the first digit is always 1 (as it should be). But when I turn the dial to set the second digit, that digit toggles between 2-3-4-5-6; in other words, no way to program anything below 120.000 or above 169.975. Undoubtedly operator error--can anyone tell me what I am doing wrong? As usual, re-re-re-reading the manual hasn't helped. 73 to all. Tom W9LCL

KB3LMV
Posts: 45
Joined: Sun May 31, 2009 2:40 am
Location: Melrose Fl.

Icom programming

Post by KB3LMV » Sun Apr 25, 2010 3:26 am

Programming an Icom is a real treat,start a a given page then bounce around to about six more,Oh Yes pray it doesn't time out before your finished.Buy the programming software,Write your own Instruction sheets, or trade it for a Yaesu
Good Luck & Happy Swearing
Paul
Paul KB3LMV

Post Reply