Tec question FT 100D

Just what it says -- this is the place for any discussions not related to Buying, Selling and Trading ham gear. The discussion must be related to Ham Radio.
Post Reply
KN4N
Posts: 46
Joined: Wed Oct 08, 2003 11:08 am
Location: Greeneville, TN
Contact:

Tec question FT 100D

Post by KN4N » Mon Aug 06, 2007 11:33 am

Have an FT 100D bought used. Works FB on HF and transmit on VHF but NO RECEIVE.
I have been through the manual several times, looking at the settings....unable to find anything. May be the receiver section on VHF bad. Any ideals anyone?
Bill

K4ICL
Posts: 663
Joined: Wed Mar 05, 2003 1:07 pm
Location: Greenville, SC
Contact:

Reset the computer...

Post by K4ICL » Mon Aug 06, 2007 12:13 pm

If you have not alredy done so, reset the computer. The procedure is in the back of the manual.

Also, be sure your squelch control is in the "open" position when testing for receive.

Good Luck...

AL
K4ICL

KN4N
Posts: 46
Joined: Wed Oct 08, 2003 11:08 am
Location: Greeneville, TN
Contact:

tec help ft 100D

Post by KN4N » Mon Aug 06, 2007 2:54 pm

Tnx Al for reply...we already did both of your suggestions, no help. Bill

Post Reply