FT-920 VFO-B display

Just what it says -- this is the place for any discussions not related to Buying, Selling and Trading ham gear. The discussion must be related to Ham Radio.
Post Reply
Posts: 1
Joined: Wed Aug 06, 2014 2:40 pm

FT-920 VFO-B display

Post by MM0HDW » Wed Aug 06, 2014 2:44 pm

The VFO-B display on my recently aquired ft920 vanishes but will resume when one turns the VFO knob, it again vanishes after three seconds.
also resumes when one depresses the TX or RX buttons on VFO-B .The VFO works correctly and remains active ie' only the readout vanishes
Does anyone have info on this fault?

Hamish MM0HDW

Posts: 228
Joined: Fri Aug 12, 2005 11:35 pm
Location: northwest wisconsin

Re: FT-920 VFO-B display

Post by k9yli » Wed Aug 13, 2014 2:47 pm

I will take a wild guess and think that it is a feature of the radio to blank out VFO b so that the operator doesnt look at the wrong one during operation.

its likley a menu value you set...

a full reset would likly clear it but i would think simple perusal of the menus woould show it up.

Post Reply