Nube with a Kenwood TS 830

Just what it says -- this is the place for any discussions not related to Buying, Selling and Trading ham gear. The discussion must be related to Ham Radio.
Post Reply
Jim Sayer
Posts: 1
Joined: Mon Apr 30, 2012 11:56 pm
Location: Bakersfield CA

Nube with a Kenwood TS 830

Post by Jim Sayer »

I got my ticket, a hand me down 830, and trying to get on the air.
My problem is the 830 takes a four prong microphone adapter and all the current microphones come including my MC 60, with a 7 or 8 prong connector.

What I need is an old MC 50 microphone out of someones junk pile or one willing to sell cheap. Anyone have one?
I could go out and purchase a fancy-shmany rig, with all the bells and whistles but I would rather grow into that as my skills develop.

Kenwood made an adapter at one point, but no longer.

thanks
KJ6VAS
Jim Sayer JK6VAS
lhk0pd
Posts: 715
Joined: Tue Jul 05, 2005 12:01 pm
Location: dodge city kansas
Contact:

Post by lhk0pd »

Jim you could remove the mic end on the microphone and replace it with a 4 pin. Also you can find adapters on E bay. I also believe some one has been advertising adapters on QTH. Not that hard to find and buy a Mic with the 4 pin mic connecter for a Kenwood.
Larry Huff K0pd
k9yli
Posts: 229
Joined: Fri Aug 12, 2005 11:35 pm
Location: northwest wisconsin

Post by k9yli »

better yet get a short piece of 4 conductor wire, a 4 pin plug to fit and a 8 pin socket..
wire up to match the proper lines..

PTT
Mic hot

Mic common
Shield and /or PTT common..

dont butcher the mic connector as you may want it normal later.

always build adapters....
Post Reply