Page 1 of 1


Posted: Thu Jul 19, 2012 9:25 pm
by wb6mmj
I bought some rectifiers from K9FW. When I received them 3 of them were labeled HVP15 and one is lableled HV14-1.
The first time I contacted him, before agreeing to buy them, I told him I needed 4 of them to build a full wave bridge rectifier. Also, these are labeled as 1 amp. He tried to tell me they were 3 amp rectifiers.
What he sent me is not what I wanted and when I contacted him about the problem he just said " We are done talking about this"
Not a good guy to do business with.
I got screwed on this one by him.


Posted: Fri Jul 20, 2012 10:28 am
by K9FW
What was sold WAS a Matched Quad of K2AW Diode Modules, K2AW in later years did not build up these modules himself, just relabeled purchased modules. I tried to explain this nicely over very many emails. The K2AW Built and Later the Purchased Modules use 3 amp diodes inside PER K2AW. All can be ran with much more than 1 amp following the K2AW original Spec Instructions. This was fully explained and the spec sheet was offered to this Ham. Tried very hard to work this out, even said send them back, Shipping for these is minimal.
All I got was his irritating complaints=lots. Not a reseller, just down sizing the station and spares.


K2AW Diode Modules

Posted: Fri Jul 20, 2012 10:38 am
by K9FW
I have another matched set of these with a pending sale on this site now, and if you look close at the pic 15 can be seen on them. K2AW just removed some of the original lettering and stamped his 14-1 on them. All these has been hashed over enough. Al K9FW